<acronym id="6imey"><center id="6imey"></center></acronym>
<rt id="6imey"></rt>
<acronym id="6imey"><center id="6imey"></center></acronym>
新聞動態
 中頻電爐為什么會發生功率不足?

好多設備都會因為長時間運轉而發生故障,及時設備運行正常也會應為這樣或那樣的原因引起中斷。那么中頻電爐在設備正常的情況下為什么會出現功率不足的現象呢,濟南中頻電爐維修今天就跟大家說說這其中的原因。
A lot of equipment will break down because of long-time operation, and even if the equipment is running normally, it will be interrupted for one reason or another. So why does the medium frequency electric furnace lack power when the equipment is normal? Jinan medium frequency electric furnace maintenance will tell you the reason today.
1.中頻電爐和電源不匹配,電源電壓不足自然就影響到了功率。
1. If the furnace and the power supply do not match, the power supply voltage is insufficient, which naturally affects the power.
2.如果中頻電爐的整流部分沒有調節好,整流管沒有完全導通,電壓是無法達到額定值的,也因為電壓的不足影響到了設備的功率。
2. If the rectifying part of the medium frequency electric furnace is not well adjusted, and the rectifier tube is not fully connected, the voltage can not reach the rated value, and the power of the equipment is affected by the lack of voltage.


3.中頻電爐電壓設定過高,過低都是會對中頻電爐功率產生影響的。節能中頻電爐。
3. If the voltage of medium frequency electric furnace is set too high or too low, it will affect the power of medium frequency electric furnace. Energy saving medium frequency electric furnace.
4.在中頻電爐的輸出回路存在著過大的電感諧振回路附加電感過大都會對功率產生干擾。
4. There is too much inductance in the output circuit of the medium frequency electric furnace. If the additional inductance is too large, the power will be disturbed.
中頻電爐造成漏爐、穿爐事故的原因:
The causes of leakage and penetration of medium frequency electric furnace are as follows
(1)鐵水長時間冷卻,一冷一熱,熱脹冷縮,擠壓爐襯導致爐襯產生裂紋,融化過程中鐵水從中裂紋穿出,導致穿爐,或者從結蓋噴出,造成噴爐事故。節能中頻電爐。
(1) When the hot metal is cooled for a long time, one is cold and the other is hot, the hot metal expands and shrinks, and extrudes the furnace lining, resulting in cracks in the furnace lining. During the melting process, the hot metal penetrates through the cracks, leading to furnace penetration, or ejecting from the cap, resulting in furnace spraying accident. Energy saving medium frequency electric furnace.
(2)中頻爐使用越久,爐襯較薄,隨著爐內鐵水量增加,部分承受力下降導致穿爐。
(2) The longer the medium frequency furnace is used, the thinner the lining is. With the increase of the amount of iron in the furnace, part of the bearing capacity decreases, leading to furnace penetration.
(3)爐襯局部進雜志或為滿足要求,產生缺陷,引發穿爐。節能中頻電爐。
(3) In order to meet the requirements, the furnace lining is partially filled with magazines, and defects are produced, which leads to furnace penetration. Energy saving medium frequency electric furnace.
(4)爐襯急冷產生裂紋,在熔煉過程中從裂紋中穿出。
(4) Cracks are produced in the furnace lining during rapid cooling, and come out of the cracks during smelting.
以上就是濟南電爐為大家介紹關于功率出現不足現象的介紹,希望可以幫助到大家,更多精彩內容請大家關注:http://www.ysbaijiale.com
The above is the introduction of Jinan Electric Furnace on the phenomenon of insufficient power. I hope it can help you http://www.ysbaijiale.com

 
 油罐車海底閥 鋼鋁復合暖氣片 淄博不銹鋼管廠家 燃氣回轉爐 天津紙盒
濟南金岳電爐制造有限公司 版權所有(C)2014   網絡支持   股票代碼: 002095 著作權聲明 網站管理 魯ICP備14033186號-1
欧美日本精品一区二区三区,亚洲日韩国产一区二区三区,国产欧美日韩精品视频一区二区